The Personal Safety Flashlight with 4 Safety Modes

plus Morse Code mode for signaling

 

setstats  
Important: The Photon Freedom Micro is shipped in a battery protection mode. To take it out of this mode, simply press and hold the button until the light turns off (approximately 15-20 seconds).


Operating Instructions

Simple, Intuitive Operation

All it takes is a simple squeeze of the button to give you instant full power illumination at any time. To dim the light once it is turned on, simply press and hold the button to dim the light to the desired level.

 

Pressing and holding the button when the light is already off will turn it on at the lowest level and allow you to gradually increase the brightness to give you just the amount of light you need to accomplish your task without disturbing your night vision or disrupting those around you.

 

When needed, the four safety strobe functions (fast, medium, slow, & SOS) can be accessed by continuing to hold the button down. Once the light has dimmed or brightened fully, it will proceed to cycle through the various strobe functions. Simply release the button when you reach the desired beacon mode.

 

An additional "signaling" mode can be accessed by tapping the button several times in rapid succession. When in the signaling mode, the Freedom Micro will behave like the squeeze-only Photon I, with the light turning on only while the button is pressed and off when it is released. To exit the signaling mode and return the light to normal operation, simply press and hold the button for several seconds until the light turns off.
 

Rescue After Sundown

  A snowmobile crash survivor in the high country of Colorado, who was on a solo run in search of fresh powder. A broken back left him unable to move. His subsequent rescue after sundown was attributed to him finally being spotted because of his blinking Photon Light.